Log-Gevity™ Interior Grade Finish Coat is for use on all interior vertical log/wood surfaces susceptible to moisture damage including all types of dimensional lumber.

Interior Grade Finish Coat Product Features
• Breathable.
• Natural wood finish.
• Cleanable.
• Available in pigments.
• Water-repellants.

Interior Grade Finish Coat Product Benefits
• Non-film forming penetrant.
• Provides aesthetically appealing, natural looking, rich warm glow commonly associated with natural wood finishes.
• Can be used in humid, high moisture conditions (saunas, etc.).

Interior Grade Finish Coat Coverage Rate
• Approximately 200 sq. ft. per gallon.
• For best results and optimal penetration surface must be dry durning appliacation.
• Both surface and air temperature must be above 50°F.

Interior Grade Finish Coat Application Instructions
• Apply a coat of Log-Gevity Interior Grade Finish Coat with a low pressure (HVLP) sprayer or airless sprayer.
• When using a pressure sprayer, always back brush into surface.
• After the first coat has flash dried, which may take 30 minutes or longer, it may be necessary to apply a second coat of Interior Grade Finish Coat for a uniform effect.
• To avoid runs and streaking, back brush product from surfaces before drying.
• Keep a wet edge to avoid lap marks.
• Allow at least 24 hours to dry.
• Clean up: Use mineral spirits or dish detergent and water.
• If Interior Grade Finish Coat comes in contact with surfaces such as glass, paint, metal, caulking or rubber, remove immediately with soap and water.